To look after your new 3d Printed Products make sure that they are not exposed to high heats.
Wash them in cold water only.
DO NOT put in the dishwasher or wash in hot water, this will distort the molds and make them unusable.
Towel dry and air dry for at least a day as 3d printing holds moisture and by airdrying for an extended amount of time will ensure that excess moisture dries out.
To use in between batches brush out with a dry paintbrush or a dry cloth.
Just remember under NO circumstances should you put your 3d printed products near heat.
If you have any rough bits or uneven lines take some wet and dry sandpaper and give it a sand down followed by a thorough wash.
If you have any questions or are struggling to use your molds please visit our facebook group, www.facebook.com/groups/sirenmolds there are people in there always happy to help. 3d Molds can be tricky at first but dont lose hope, once you master them you will be hooked.
Our 3d printed molds do not require a press they are designed to be used without a press and to be done by hand.