Custom Puck 3 Piece Mold

Description

Available in 2″ (50.8mm), 2.5″ (63.5mm), 3″ (76.2mm), 3.5″ (88.9mm) or 4″ (101.6 mm)

These are printed on order so there is a lead time please check our Facebook group for the dates being printed or our site wide banner above.

There is a limit to how much writing can go on them so if you are unsure please check with us.

Please note this is for 1 puck mold which has
2 Plates 
1 Shell

If you are wanting the puck set which has what is in the image please order from that product listing not this one.

Make sure that when you are finished with your mold that you wash it in COLD water and towel dry or air dry for at least a day. Do not use hot water or put it in the dishwasher otherwise it can warp and ruin the mold. These are printed with PLA and do not handle high heat well.